Shrink disc stainless steel 23380-01-3060
- To connect a hollow shaft to a shaft
- Suitable for static, dynamic and shock loads
- For very high torques
- No shift of axial shaft/hub during assembly
- Self-centring
Unité de vente
€94.19
hors TVA
Ajouté à votre panier
Désignation
Frette de serrage
Matériau
du corps de base
acier inoxydable
D1=Outside diameter
60
D=internal diameter
30
B
27
Code acier
1.4057
Couple M en Nm
transmissible au
couple de serrage MS
212/240/265
DW
24/25/26
Force axiale F en kN
transmissible au
couple de serrage MS
38/41/43
L
23
L1
18
Nombre de
vis de serrage
7 x M5
Pression superficielle
sur le moyeu P
N/mm²
180
Tightening torque
MS
Nm
3
~ CONFLICT MINERALS 3TG status
no intentional 3TG
~ CP65 substance 2 cancer
nickel (metallic)
~ PFAS free?
yes
~ REACH SVHC-free?
yes
~ RoHS conformity
yes, without exemption
~ TSCA 6(H) conformity
yes
Description
Material
Stainless steel 1.4057.
Version
Bright.
Note
Shrink disc to connect a hollow hub to a shaft. They are mounted on the OD of the hub and generate pressure on the hub wall by reducing the ID with wedge-formed rings, creating a press fit between the hub and shaft. They are suitable for static, dynamic and shock loads.
- for extremely high torques
- no axial shaft/hub offset when assembling
- self-centring
The version 23380-01-4072 has high tensile ISO 4762 screws.
- for extremely high torques
- no axial shaft/hub offset when assembling
- self-centring
The version 23380-01-4072 has high tensile ISO 4762 screws.
Assembly
Remove existing transportation locks. Clean and lightly oil shaft, internal and external hub diameters. Do not use MoS2 or grease. Slide shrink disc onto hub. Then slide unit (shrink disc/hub) onto shaft and position correctly. Gently tighten clamping screws one after the other by hand. Then use a torque wrench to tighten the clamping screws crosswise in several increments to the defined tightening torque MS.
1st increment approx. 33% MS
2nd increment approx. 66% MS
3rd increment 100% MS
Dismantling: Gradually loosen all screws one after the other but do not fully remove from the thread. The shrinking disc usually loosens itself.
1st increment approx. 33% MS
2nd increment approx. 66% MS
3rd increment 100% MS
Dismantling: Gradually loosen all screws one after the other but do not fully remove from the thread. The shrinking disc usually loosens itself.
Remarque importante concernant le téléchargement des modèles CAO
Pour pouvoir télécharger nos modèles CAO, vous devez d’abord connecter. Si vous n’avez pas encore créé de compte, inscrivez-vous en cliquant sur « Mon compte » (à droite de l’écran) et suivez les instructions.
D'autres clients ont également acheté
